We now can offer you full faster turn around service
and tooling support for all your molded cable assembly requirements.
This is based on a technology that uses new polymer materials. These
new polymer materials can be handled at lower temperatures than
typical injection moulding materials and machines, by virtue of
having a lower melting point / moulding settings( dew points) .
These dew points melt the polymer material at a much lower pressures,
thus making this polymer moulding process, easier and faster to
handle than the required long lead time process associated with
the typical injection moulding equipment.
If you have a moulded assembly in your near future or released
products, we may be able to produce a sample for your evaluation
from a selection of already built moulding units, in either encapsulation
of components for protection, or simply a molded cable assembly.
We invite you to try and evaluate this new tecchnology and find
out how much you can save by utilizing this new polymer process.
You will be amazed to see the savings when comparing the costs of
the typical moulding processes. Can be used for short runs of moulded
cable assemblies, ( depending on proyect and complexity) or, off
course, also in higher quantities. You can also save on the initial
high costs usually associated with typical injection moulding tooling
costs, since tooling for this particular process can be done typically
in less than a week's time.
Here are a few examples of the capabilities for the new process:
|
